| • संतृप्ति वोल्टता | |
| saturation: नमी परिपूर्णता | |
| voltage: खिंचाव तनाव | |
saturation voltage मीनिंग इन हिंदी
saturation voltage उदाहरण वाक्य
उदाहरण वाक्य
अधिक: आगे- In IGBT, charge carrier concentration at emitter side in n-base layer is low as saturation voltage.
- By contrast, the standard two-transistor mirror operates down to the saturation voltage of its output transistor.
- This allows the voltage drop from the unregulated voltage to the regulated voltage to be as low as the saturation voltage across the transistor.
- Carrier distribution in n-base is similar to that of saturation bipolar transistor and low saturation voltage of MCS, even at high voltage ratings, can be achieved.
- Trouble is, you need to produce a voltage exceeding the saturation voltage of the transistor ( V CEsat ) and a few 10's of microamps for it to work.
- An additional complication is that liquids also exhibit a saturation phenomenon : after certain voltage, the saturation voltage, the further increase of voltage will not change the contact angle, and with extreme voltages the interface will only show instabilities.
- Since the circuit was biased for high frequency operation ( \ scriptstyle V _ { BE } ~ \ ge ~ 0.7 ), this represents a saturation voltage for Q3 of 0.1 to 0.2 volts.
- The transistor is designed so that its collector saturation voltage ( ) is less than the base emitter voltage ( roughly 0.6 V ) minus the Shottky diode's forward voltage drop ( roughly 0.2 V ).
- A July 2008 press release states the PET plastic matrix allows for better crystal polarization and that this " along with other proprietary processing steps provides the potential of a polarization saturation voltage required by EEStor, Inc . " The patent states this is done at 180 �C with 4000 V.
- Even in a transistorised amplifier with hard clipping, the gain of the transistor will be reducing ( leading to nonlinear distortion ) as the output current increases and the voltage across the transistor reduces close to the saturation voltage ( for bipolar transistors ), and so " full power " for the purposes of measuring distortion in amplifiers is usually taken as a few percent " below " clipping.
